Burst Pipe Water Extraction in Houston
A burst pipe keeps pushing water into drywall, cabinets and flooring until the main is shut. Extraction crews across Harris County pump out the flood, map the wet walls and start structural drying. Call 24/7.
Call the 24/7 crew (888) 926-4485
- Attic, wall and slab-level ruptures
- Moisture mapped behind drywall
- Drying logged on every visit
Burst Pipe Water Extraction: What the Crew Handles
Houston homes have no basements to catch a burst pipe. Water goes straight into slab-level floors, or it drops from an attic run through the ceiling and down inside the walls. Older bungalows around the Heights and Montrose can still have galvanized steel rusting from the inside, and suburban homes from the late 1970s to the mid 1990s sometimes carry gray polybutylene.
Once the main is closed, the crew pumps out the flood, finds every wet cavity with meters and sizes the drying equipment room by room. Call (888) 926-4485 while the water is still moving.
- Water category: Category 1 at the start, so speed matters
- Common Houston causes: Attic runs, aged galvanized or copper, failed PEX fittings
- Freeze exposure: Rare, yet the February 2021 freeze split pipes countywide
- Who fixes what: The plumber fixes the pipe, the crew dries the house
Signs You Need Burst Pipe Water Extraction
- Water rushing inside a wall while every fixture is shut.
- Wet baseboards or a puddle far from the nearest sink.
- A meter dial that spins when nobody is using water.
- A ceiling stain that grows or a drywall bubble that sags.
- Weak pressure right after a loud bang in the walls.
How Burst Pipe Water Extraction Works
-
Shut off and make safe
The crew confirms the main stays closed and turns off breakers that feed wet outlets before any equipment comes inside.
-
Pump out the flood
Truck-mounted units and portable extractors pull standing water off tile, vinyl and carpet, and the crew lifts any pad that holds too much.
-
Map the moisture
Thermal imaging and pinless meters show which walls, cabinets and floor zones stay wet, so drywall is opened only where readings call for it.
-
Dry to the standard
LGR dehumidifiers and air movers run on the framing while the crew logs readings daily and compares each material to a dry reference, per IICRC S500.
Stop the damp from spreading (888) 926-4485
What to Do Before the Crew Arrives
- Close the main valve, usually at the meter box near the street or on an exterior wall.
- Flip off breakers for any room where water touches outlets or cords.
- Open a faucet on the lowest level to drain pressure out of the pipes.
- Lift rugs, electronics, books and papers off wet floors.
- Photograph the split pipe and every wet room before anything moves.
What to Expect From the Crew
-
Water does not wait
A supply pipe feeds the flood around the clock, so Houston Water Extraction Pros keeps dispatch open 24/7 for burst pipe calls.
-
The hidden spread is the real job
Water from an attic run can soak a ceiling, drop through a wall and reach the slab edge, and the crew checks every stop along that path.
-
Records the claim needs
Timestamped photos, a moisture map and daily readings show the insurer when the loss happened and how the drying went.
What Does Burst Pipe Water Extraction Cost?
A burst pipe that wets one or two rooms typically runs $1,500 to $6,500 for extraction and drying, with the plumber billed separately.
- One room, hard flooring: $1,500 to $3,200. Typical when the drywall dries in place.
- Wall or ceiling cavity opened: $3,200 to $6,500. Typical once wet insulation and board get cut out.
- Several rooms or two floors: $6,500 to $14,000. Typical when carpet, pad and downstairs ceilings are all wet.
What changes the price
- Square footage the water reached
- Drywall, insulation and flooring removed
- Hours between the burst and the first extraction
- Slow-drying materials like hardwood and cabinetry
For a rough number, try the water extraction cost calculator.
Insurance Records for Burst Pipe Water Extraction in Houston
Deductibles apply to water claims, and a small leak can cost less to dry than the deductible. The crew still provides photos and readings, so the owner can decide whether filing makes sense.
Coverage depends on your policy, so check with your own insurer.
Burst Pipe Water Extraction in Houston by City
Busy cities for this service. Every town has its own page.
Related Water Damage Services
-
Frozen Pipe Water Extraction in Houston
Handles the flood that starts when a frozen pipe thaws, from soaked attic insulation down to the slab.
-
Slab Leak Water Extraction in Houston
Dries the floors, baseboards and lower walls soaked when a pipe under the concrete leaks upward.
-
Water Heater Leak Extraction in Houston
Clears the flood from a leaking or failed tank and dries whatever the water reached around it.
-
AC Condensate Leak Water Extraction in Houston
Removes condensate water from attics, closets and ceilings after an air conditioner drain backs up.
-
Washing Machine Overflow Water Extraction in Houston
Clears water from a burst washer hose or backed-up drain and dries the floors beyond the laundry room.
-
Toilet Overflow Water Extraction in Houston
Pumps out overflow water, removes soaked flooring and sanitizes the bathroom and nearby rooms.
Questions About Burst Pipe Water Extraction in Houston
Burst Pipe Water Extraction Questions
Do pipes really burst in Houston's mild winters?
Yes. Hard freezes are rare, but they catch attic and exterior-wall pipes unprotected, and the February 2021 freeze split pipes across Harris County. Pressure and age break pipes in any season.
Does the plumber or the extraction crew come first?
Close the main first. The plumber fixes the pipe and the crew handles the water and drying, so the two trades often work in the house at the same time.
Does every wet wall get cut open?
No. The crew reads each wall with a meter and cuts drywall only where the cavity is holding water or soaked insulation.
How long does drying take after a burst pipe?
A contained loss usually dries in three to five days. Hardwood, insulation and thick framing take longer, and the daily readings decide when equipment comes out.
Does homeowners insurance cover a burst pipe?
A sudden burst is often covered, while slow leaks and wear usually are not. Coverage depends on the policy, so check with your own insurer.
Why does speed matter so much?
Water wicks up drywall and into the subfloor every hour it sits, and mold can start growing within 24 to 48 hours. That is why dispatch runs 24/7.
A quick meter test from the EPA WaterSense leak checks shows whether a hidden pipe is still running.
Questions about a water main or the meter box at the curb go to the City of Houston.
Standing water keeps moving into drywall, subfloor and insulation. The sooner extraction starts, the less has to come out.